To the right of your camera.
Blink security camera turn off blue light.
Have a paperclip ready to go and put it to the side go to the cloud button on the app after you press it it probably says sync module is off line.
You can always turn it back on at night.
Blink xt and xt2 have a physical hardware switch inside the camera to control whether the status light is on or off.
This led is enabled by default from the factory.
For all cameras other than the indoor the blue light can be turned off.
Slow blinking pattern blue light.
Firmware update in progress.
There is no small red light that shows it s recording.
Camera is starting up.
I have a write up on my blog kentavos.
With the release of blink xt we have been able to add a feature to it to allow you to toggle the blue recording light.
Very slow pulsing light blue.
If you own a blink security camera you have probably noticed that the camera displays a blue led light whenever it is recording motion.
This led is enabled by default from the factory.
Honestly i don t know how the blink folks seem to think having the light come on only when its recording and off when its not is a security feature.
This article will show you how to turn off the blue recording led on blink xt.
I just wanted to help anybody who has this issue apparently my internet went down while i was sleeping to fix the problem do this.
Blink cameras have an activity indicator in the form of a blue color led light on the front of the camera.
Remove the battery cover.
Applies to xt and xt2 cameras only.
If you open the back cover on your blink xt2 camera you will find a small switch beside the right battery slot.
Light blinks on and off then is on for two seconds blue.
The recording light is blue and that can be shut off.
Camera is in setup mode.
The red light you see is the ir illuminator.
As far as the blue indicator light just cover it with electrical or white tape if it is an issue.
A walk through on taking the blink camera apart and hiding the blue light that comes on when the camera is recording.
Take a look at the photograph below.
In this guide i will show you how to disable this light.
I guess it is a pro burglar security feature.
Light blinks on for.
By confirmation there is no red light during daytime.
Then if you decided later to undo it you could just clean the hole again and volla blue light.
There are no other red lights.
The xt and xt2 cameras have a hardware switch inside the battery compartment to control the blue recording light.
This feature is not available on the blink indoor cameras.
This article will show you how to turn off the blue recording led on blink xt.
This feature is not available on the blink indoor cameras.
If you turn off ir illumination the red light disappears but of course you have no night vision.
